Mud pump

1, can transport high concentration and high viscosity & LT; 10000PaS and suspended grout containing particles.

2, the conveying liquid flow is stable, no overflow, pulsation and stirring, shearing slurry phenomenon.

3, discharge pressure has nothing to do with speed, low flow can also maintain high discharge pressure.

4. The flow rate is proportional to the speed, and the flow rate can be adjusted by the variable speed mechanism or the speed regulating motor.

5, strong self-priming ability, no bottom valve can be directly pumped liquid.

6, the pump can be reversed, the flow of liquid by the direction of rotation of the pump to change, suitable for the pipeline to reverse flushing occasions.

7, smooth operation, low vibration and noise.

8, simple structure, convenient disassembly and maintenance.

I-1b thick pulp pump is widely used in chemical, pharmaceutical, brewing, paper making, food and other units.

Mud pump cylinder liner, cylinder top sleeve, cylinder head, pull rod,

Piston, piston pressure plate, cup, piston, piston rod, piston rod, into the drain valve, into the drain valve seat, crosshead, crosshead, crosshead pin shaft, crankshaft, connecting rod, connecting rod and watts, copper sets, connecting rod bolt and mother, crown type nut, skeleton oil seal, O ring, bearings and matching gear, shaft or the quality problem, Attention should be paid to purchase and use.

Before starting the mud pump, please check whether the inlet pipe and outlet pipe are blocked, whether the forward and rear bearings are filled with butter, and check whether the root is full. Mud pump work should be equipped with high pressure water pump, will be greater than the mud pump pressure of water to the leakproof packing, protection of the packing, mud pump work should not be closed flushing pump, otherwise, will make the seal part quickly wear. Whether the clearance between impeller and guard plate is reasonable has a great impact on the life of mud pump. If the clearance is not reasonable, the pump will produce vibration and noise when running, and the flow parts will be damaged quickly. Therefore, when replacing the impeller, attention should be paid to the clearance meeting the requirements of the drawings. The clearance adjustment can be carried out by adjusting screws on the back bearing body. The allowable suction range of mud pump is measured when conveying clean water, and the influence of mud on suction capacity should be considered when pumping mud.